Tbi Injector Color Codes
Tbi Injector Color Codes. Injector driver a (also injector 1) is ecm pin d16 with a lt grn wire then spliced to a blu (blue) wire. For injectors they come in various flow rates.
Which is 74 #/hr at the 30 psi these tbi units use. One is red and the other is a blue one. They will have to be removed from the pod.
Which Is 74 #/Hr At The 30 Psi These Tbi Units Use.
Orange/black 5 this appears to be a kit used when replacing the injectors, but there are other gaskets and washers for the fuel. Keep tbi simple is my rule. The harness will work with almost any of the gm tbi ecms that do not have the electronic shifting.
Dallas, Tx By Hudsonhawk » Fri Feb 25, 2005 5:16 Pm The Color Codes Should Be Somewhere On The Injector Themselves.
Spend that money on the new distributor and good plug wires. 0l 40 lb/hr gm 5235279 you want: Injector driver b (also injector 2) is ecm pin d14 with a lt grn wire then.
On The Up Side They Come With A 30 Psi.
The 1995 throttle body fuel injection (tbi) system's computer has 2 connectors. They will have to be removed from the pod. 33 #/hr * 4.3l engine:
Injector Driver A (Also Injector 1) Is Ecm Pin D16 With A Lt Grn Wire Then Spliced To A Blu (Blue) Wire.
One is red and the other is a blue one. Each connector has 2 rows. For injectors they come in various flow rates.
For Coil, Tbi Is Typically Fine For The Stock Coil But I Don’t Have A Problem If You Use A Performance.
The wire colors are the same as the factory wire colors for car and truck tbi injected engines. * 2.8l and 3.1l engines: The common injectors that are found in the above tbi units are:
Post a Comment for "Tbi Injector Color Codes"